Lines Matching +full:sub +full:- +full:module

9 a reset provider (e.g. power management or clock module) and received by a
10 reset consumer (the module being reset, or a module managing when a sub-
11 ordinate module is reset). This binding exists to represent the provider and
15 specifier - a list of DT cells that represents the reset signal within the
35 #reset-cells:	Number of cells in a reset specifier; Typically 0 for nodes
41 	rst: reset-controller {
42 		#reset-cells = <1>;
51 		#reset-cells, then only the phandle portion of the pair will
55 reset-names:	List of reset signal name strings sorted in the same order as
56 		the resets property. Consumers drivers will use reset-names to
63 		reset-names = "reset";
70 		reset-names = "i2s1", "i2s2", "dma", "mixer";
73 This represents a bus that controls the reset signal of each of four sub-