Lines Matching +full:button +full:- +full:191

4  * Maxime Ripard <maxime.ripard@free-electrons.com>
6  * This file is dual-licensed: you can use it either under the terms
45 /dts-v1/;
46 #include "sun5i-a13.dtsi"
47 #include "sunxi-common-regulators.dtsi"
49 #include <dt-bindings/gpio/gpio.h>
50 #include <dt-bindings/input/input.h>
53 	model = "Olimex A13-Olinuxino";
54 	compatible = "olimex,a13-olinuxino", "allwinner,sun5i-a13";
61 		stdout-path = "serial0:115200n8";
65 		compatible = "gpio-leds";
66 		pinctrl-names = "default";
67 		pinctrl-0 = <&led_pins_olinuxino>;
71 			default-state = "on";
76 		compatible = "dumb-vga-dac";
79 			#address-cells = <1>;
80 			#size-cells = <0>;
86 					remote-endpoint = <&tcon0_out_vga>;
94 					remote-endpoint = <&vga_con_in>;
101 		compatible = "vga-connector";
105 				remote-endpoint = <&vga_bridge_out>;
127 		compatible = "x-powers,axp209";
131 		interrupt-controller;
132 		#interrupt-cells = <1>;
145 	vref-supply = <&reg_vcc3v0>;
148 	button-191 {
155 	button-392 {
162 	button-601 {
169 	button-795 {
176 	button-987 {
185 	vmmc-supply = <&reg_vcc3v3>;
186 	bus-width = <4>;
187 	cd-gpios = <&pio 6 0 GPIO_ACTIVE_LOW>; /* PG0 */
200 	led_pins_olinuxino: led-pin {
203 		drive-strength = <20>;
218 	pinctrl-names = "default";
219 	pinctrl-0 = <&lcd_rgb666_pins>;
226 		remote-endpoint = <&vga_bridge_in>;
231 	pinctrl-names = "default";
232 	pinctrl-0 = <&uart1_pg_pins>;
242 	usb0_id_det-gpios = <&pio 6 2 (GPIO_ACTIVE_HIGH | GPIO_PULL_UP)>; /* PG2 */
243 	usb0_vbus_det-gpios = <&pio 6 1 (GPIO_ACTIVE_HIGH | GPIO_PULL_DOWN)>; /* PG1 */
244 	usb0_vbus-supply = <&reg_usb0_vbus>;
245 	usb1_vbus-supply = <&reg_usb1_vbus>;