Lines Matching +full:bank +full:- +full:name

10 Please refer to pinctrl-bindings.txt in this directory for details of the
18 such as pull-up, multi drive, etc.
21 - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl"
22 		or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl"
23 - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be
24   configured in this periph mode. All the periph and bank need to be describe.
29 Each line will represent a pio bank
33 Bank: 3 (A, B and C)
41 For each peripheral/bank we will describe in a u32 if a pin can be
45 From the datasheet Table 10-2.
83 - atmel,pins: 4 integers array, represents a group of pins mux and config
90 MULTIDRIVE	(1 << 1): indicate this pin needs to be configured as multi-drive.
91 			Multi-drive is equivalent to open-drain type output.
97 				00 - No change (reset state value kept)
98 				01 - Low
99 				10 - Medium
100 				11 - High
108 Some requirements for using atmel,at91rm9200-pinctrl binding:
111 2. The driver can use the function node's name and pin configuration node's
112    name describe the pin function and group hierarchy.
113    For example, Linux at91 pinctrl driver takes the function node's name
114    as the function name and pin configuration node's name as group name to
118 4. The gpio controller must be describe in the pinctrl simple-bus.
120 For each bank the required properties are:
121 - compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or
122   "microchip,sam9x60-gpio"
123 - reg: physical base address and length of the controller's registers
124 - interrupts: interrupt outputs from the controller
125 - interrupt-controller: marks the device node as an interrupt controller
126 - #interrupt-cells: should be 2; refer to ../interrupt-controller/interrupts.txt
128 - gpio-controller
129 - #gpio-cells: should be 2; the first cell is the GPIO number and the second
130   cell specifies GPIO flags as defined in <dt-bindings/gpio/gpio.h>.
131 - clocks: bank clock
136 	#address-cells = <1>;
137 	#size-cells = <1>;
139 	compatible = "atmel,at91rm9200-pinctrl", "simple-bus";
143 		compatible = "atmel,at91sam9x5-gpio";
146 		#gpio-cells = <2>;
147 		gpio-controller;
148 		interrupt-controller;
149 		#interrupt-cells = <2>;
153 	atmel,mux-mask = <
162 		pinctrl_dbgu: dbgu-0 {
171 	compatible = "atmel,at91sam9260-usart";
174 	pinctrl-names = "default";
175 	pinctrl-0 = <&pinctrl_dbgu>;