Lines Matching +full:mdio +full:- +full:gpio0

2 ---------------------------------------
10 Marvell Switches are MDIO devices. The following properties should be
11 placed as a child node of an mdio device.
17 which is at a different MDIO base address in different switch families.
18 - "marvell,mv88e6085"	: Switch has base address 0x10. Use with models:
22 - "marvell,mv88e6190"	: Switch has base address 0x00. Use with models:
24 - "marvell,mv88e6250"	: Switch has base address 0x08 or 0x18. Use with model:
28 - compatible		: Should be one of "marvell,mv88e6085",
31 - reg			: Address on the MII bus for the switch.
35 - reset-gpios		: Should be a gpio specifier for a reset line
36 - interrupts		: Interrupt from the switch
37 - interrupt-controller	: Indicates the switch is itself an interrupt
39 #interrupt-cells = <2>	: Controller uses two cells, number and flag
40 - eeprom-length		: Set to the length of an EEPROM connected to the
44 - mdio			: Container of PHY and devices on the switches MDIO
46 - mdio?		: Container of PHYs and devices on the external MDIO
48 			  "marvell,mv88e6xxx-mdio-external"
52 	mdio {
53 		#address-cells = <1>;
54 		#size-cells = <0>;
55 		interrupt-parent = <&gpio0>;
57 		interrupt-controller;
58 		#interrupt-cells = <2>;
63 			reset-gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
65 			mdio {
66 				#address-cells = <1>;
67 				#size-cells = <0>;
70 					interrupt-parent = <&switch0>;
77 	mdio {
78 		#address-cells = <1>;
79 		#size-cells = <0>;
80 		interrupt-parent = <&gpio0>;
82 		interrupt-controller;
83 		#interrupt-cells = <2>;
88 			reset-gpios = <&gpio5 1 GPIO_ACTIVE_LOW>;
90 			mdio {
91 				#address-cells = <1>;
92 				#size-cells = <0>;
95 					interrupt-parent = <&switch0>;
101 				compatible = "marvell,mv88e6xxx-mdio-external";
102 				#address-cells = <1>;
103 				#size-cells = <0>;