Lines Matching +full:k2g +full:- +full:sci +full:- +full:clk
10 --------------------
11 - compatible:
12 Should be "ti,omap2-hsmmc", for OMAP2 controllers
13 Should be "ti,omap3-hsmmc", for OMAP3 controllers
14 Should be "ti,omap3-pre-es3-hsmmc" for OMAP3 controllers pre ES3.0
15 Should be "ti,omap4-hsmmc", for OMAP4 controllers
16 Should be "ti,am33xx-hsmmc", for AM335x controllers
17 Should be "ti,k2g-hsmmc", "ti,omap4-hsmmc" for 66AK2G controllers.
20 ---------------------------------
22 - ti,hwmods: Must be "mmc<n>", n is controller instance starting 1.
25 - power-domains:Should contain a phandle to a PM domain provider node
28 Documentation/devicetree/bindings/soc/ti/sci-pm-domain.yaml
29 - clocks: Must contain an entry for each entry in clock-names. Should
31 usage in Documentation/devicetree/bindings/clock/ti,sci-clk.yaml
32 - clock-names: Shall be "fck" for the functional clock,
37 --------------------
38 - ti,dual-volt: boolean, supports dual voltage cards
39 - <supply-name>-supply: phandle to the regulator device tree node
40 "supply-name" examples are "vmmc",
42 - ti,non-removable: non-removable slot (like eMMC)
43 - ti,needs-special-reset: Requires a special softreset sequence
44 - ti,needs-special-hs-handling: HSMMC IP needs special setting
46 - dmas: List of DMA specifiers with the controller specific
49 - dma-names: List of DMA request names. These strings correspond
59 compatible = "ti,omap4-hsmmc";
62 ti,dual-volt;
63 bus-width = <4>;
64 vmmc-supply = <&vmmc>; /* phandle to regulator node */
65 ti,non-removable;
71 compatible = "ti,omap4-hsmmc";
74 ti,dual-volt;
75 bus-width = <4>;
76 vmmc-supply = <&vmmc>; /* phandle to regulator node */
77 ti,non-removable;
80 dma-names = "tx", "rx";
88 ------
90 ------
94 ------ ------- -----
95 | card | -- CIRQ --> | hsmmc | -- IRQ --> | CPU |
96 ------ ------- -----
120 compatible = "ti,am33xx-hsmmc";
122 pinctrl-names = "default", "idle", "sleep"
123 pinctrl-0 = <&mmc1_pins>;
124 pinctrl-1 = <&mmc1_idle>;
125 pinctrl-2 = <&mmc1_sleep>;
127 interrupts-extended = <&intc 64 &gpio2 28 IRQ_TYPE_LEVEL_LOW>;
131 pinctrl-single,pins = <