Lines Matching +full:read +full:- +full:delay

7 by mmc.txt and the properties used by the sdhci-esdhc-imx driver.
10 - compatible : Should be "fsl,<chip>-esdhc", the supported chips include
11 	       "fsl,imx25-esdhc"
12 	       "fsl,imx35-esdhc"
13 	       "fsl,imx51-esdhc"
14 	       "fsl,imx53-esdhc"
15 	       "fsl,imx6q-usdhc"
16 	       "fsl,imx6sl-usdhc"
17 	       "fsl,imx6sx-usdhc"
18 	       "fsl,imx6ull-usdhc"
19 	       "fsl,imx7d-usdhc"
20 	       "fsl,imx7ulp-usdhc"
21 	       "fsl,imx8mq-usdhc"
22 	       "fsl,imx8mm-usdhc"
23 	       "fsl,imx8mn-usdhc"
24 	       "fsl,imx8mp-usdhc"
25 	       "fsl,imx8qm-usdhc"
26 	       "fsl,imx8qxp-usdhc"
29 - fsl,wp-controller : Indicate to use controller internal write protection
30 - fsl,delay-line : Specify the number of delay cells for override mode.
31   This is used to set the clock delay for DLL(Delay Line) on override mode
34   chapter, DLL (Delay Line) section in RM for details.
35 - voltage-ranges : Specify the voltage range in case there are software
39 - fsl,tuning-start-tap: Specify the start dealy cell point when send first CMD19
41 - fsl,tuning-step: Specify the increasing delay cell steps in tuning procedure.
42   The uSDHC use one delay cell as default increasing step to do tuning process.
43   This property allows user to change the tuning step to more than one delay
45   tuning step can't find the proper delay window within limited tuning retries.
46 - fsl,strobe-dll-delay-target: Specify the strobe dll control slave delay target.
47   This delay target programming host controller loopback read clock, and this
48   property allows user to change the delay target for the strobe input read clock.
49   If not use this property, driver default set the delay target to value 7.
55 	compatible = "fsl,imx51-esdhc";
58 	fsl,wp-controller;
62 	compatible = "fsl,imx51-esdhc";
65 	cd-gpios = <&gpio1 6 0>; /* GPIO1_6 */
66 	wp-gpios = <&gpio1 5 0>; /* GPIO1_5 */