Lines Matching +full:clock +full:- +full:falling +full:- +full:edge
2 ----------------------------------
5 - compatible: must be "atmel,at91sam9g45-isi" or "microchip,sam9x60-isi".
6 - reg: physical base address and length of the registers set for the device.
7 - interrupts: should contain IRQ line for the ISI.
8 - clocks: list of clock specifiers, corresponding to entries in the clock-names
9 property; please refer to clock-bindings.txt.
10 - clock-names: required elements: "isi_clk".
11 - pinctrl-names, pinctrl-0: please refer to pinctrl-bindings.txt.
15 defined in Documentation/devicetree/bindings/media/video-interfaces.txt.
18 ------------------------
20 - bus-width: <8> or <10> (mandatory)
21 - hsync-active (default: active high)
22 - vsync-active (default: active high)
23 - pclk-sample (default: sample on falling edge)
24 - remote-endpoint: A phandle to the bus receiver's endpoint node (mandatory).
29 compatible = "atmel,at91sam9g45-isi";
32 pinctrl-names = "default";
33 pinctrl-0 = <&pinctrl_isi_data_0_7>;
35 clock-names = "isi_clk";
38 remote-endpoint = <&ov2640_0>;
39 bus-width = <8>;
40 vsync-active = <1>;
41 hsync-active = <1>;
50 pinctrl-names = "default";
51 pinctrl-0 = <&pinctrl_pck0_as_isi_mck &pinctrl_sensor_power &pinctrl_sensor_reset>;
52 resetb-gpios = <&pioE 11 GPIO_ACTIVE_LOW>;
53 pwdn-gpios = <&pioE 13 GPIO_ACTIVE_HIGH>;
55 clock-names = "xvclk";
56 assigned-clocks = <&pck0>;
57 assigned-clock-rates = <25000000>;
61 remote-endpoint = <&isi_0>;
62 bus-width = <8>;