Lines Matching +full:single +full:- +full:master

8 -----------------------------
10 - #address-cells  - should be <1>. Read more about addresses below.
11 - #size-cells     - should be <0>.
12 - compatible      - name of I2C bus controller
18 are described by a single value.
21 -----------------------------
26 - clock-frequency
29 - i2c-bus
31 	devices and non-I2C devices, the 'i2c-bus' subnode can be used for
32 	populating I2C devices. If the 'i2c-bus' subnode is present, only
34 	'#address-cells' and '#size-cells' must be defined under this subnode
37 - i2c-scl-falling-time-ns
41 - i2c-scl-internal-delay-ns
44 - i2c-scl-rising-time-ns
48 - i2c-sda-falling-time-ns
52 - i2c-analog-filter
55 - i2c-digital-filter
58 - i2c-digital-filter-width-ns
60 	(i2c-digital-filter). This width is specified in nanoseconds.
62 - i2c-analog-filter-cutoff-frequency
63 	Frequency that the analog filter (i2c-analog-filter) uses to distinguish
66 	a low-pass analog filter). Typical value should be above the normal
67 	i2c bus clock frequency (clock-frequency).
70 - multi-master
71 	states that there is another master active on this bus. The OS can use
73 	all the time, for example. Can not be combined with 'single-master'.
75 - pinctrl
79 - scl-gpios
82 - sda-gpios
85 - single-master
86 	states that there is no other master active on this bus. The OS can use
88 	Can not be combined with 'multi-master'.
90 - smbus
95 - smbus-alert
96 	states that the optional SMBus-Alert feature apply to this bus.
98 - mctp-controller
103 --------------------------------------
105 - compatible
108 - reg
118 --------------------------------------
123 - host-notify
126 - interrupts
129 - interrupt-names
133 - reg-names
137 - wakeup-source
145 adapters that support this feature, may use "host-notify" property. I2C