Lines Matching +full:1 +full:gb

7 .\" 1. Redistributions of source code must retain the above copyright notice,
37 .Nd "Chelsio T4-, T5-, and T6-based 100Gb, 40Gb, 25Gb, 10Gb, and 1Gb Ethernet adapter driver"
92 driver supports 100Gb and 25Gb Ethernet adapters based on the T6 ASIC:
109 driver supports 40Gb, 10Gb and 1Gb Ethernet adapters based on the T5 ASIC:
140 driver supports 10Gb and 1Gb Ethernet adapters based on the T4 ASIC:
199 The default is 1.
203 The holdoff timer list has the values 1, 5, 10, 50, 100, and 200
207 The default value is 1 which means the timer value is 5us.
213 The packet-count list has the values 1, 8, 16, and 32 by default,
216 The default value is -1 which means packet counting is disabled and interrupts
242 Bit 0 represents INTx (line interrupts), bit 1 MSI, and bit 2 MSI-X.
247 -1 indicates the driver should determine whether to enable or disable PCIe RO.
249 1 enables PCIe RO.
251 The default is -1.
254 1 allows the driver to install a new firmware if internal driver
260 The default is 1.
271 The default is -1 which lets the driver pick a pad boundary.
275 -1 disables congestion feedback and is not recommended.
278 1 instructs the hardware to drop frames destined for congested queues.
282 Bit 0 is rx_pause, bit 1 is tx_pause, bit 2 is pause_autoneg.
283 rx_pause = 1 instructs the hardware to heed incoming PAUSE frames, 0 instructs
285 tx_pause = 1 allows the hardware to emit PAUSE frames when its receive FIFO
287 pause_autoneg = 1 overrides the rx_pause and tx_pause bits and instructs the
289 The default is 7 (all three = 1).
295 -1 (default) means driver should automatically pick a value.
298 Bit 0 enables RS FEC, bit 1 enables BASE-R FEC (aka Firecode FEC), bit
313 1 enables autonegotiation.
314 The default is -1 which lets the driver pick a value.
315 dev.<port>.X.autoneg is -1 for port and module combinations that do not support
320 The default is -1 which lets the driver decide.
321 0 or 1 explicitly disable or enable this feature.
357 Setting this to 1 instructs the driver to use VM work requests to transmit data.
368 Set to 1 to enable the "attack filter".
372 loopback (127.x.y.z); src ip6 is not unicast; src/dst ip6 is loopback (::1/128)
376 Set to 1 to drop all incoming IP fragments.
380 Set to 1 to drop incoming frames with Layer 2 length or checksum errors.
381 Default is 1.
383 Set to 1 to drop incoming frames with IP version, length, or checksum errors.
387 Set to 1 to drop incoming frames with Layer 4 (TCP or UDP) length,