Lines Matching +full:use +full:- +full:ring +full:- +full:sense

5 .\" Redistribution and use in source and binary forms, with or without
19 .\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
22 .\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
35 .Bd -ragged -offset indent
45 the Xilinx Zynq-7000, the Xilinx Zynq UltraScale+, and the SiFive
51 .Bl -tag -width ".Cm 10baseT/UTP"
65 .Cm full-duplex
67 .Cm half-duplex
75 .Cm full-duplex
77 .Cm half-duplex
82 .Cm full-duplex
89 .Bl -tag -width ".Cm full-duplex"
90 .It Cm full-duplex
91 Force full-duplex operation.
92 .It Cm half-duplex
93 Force half-duplex operation.
98 The device and driver also support 1536-byte frames for VLANs (vlanmtu).
105 .Bl -tag -width "xxxxxxxx"
113 not be immediately removed from the receive buffer ring but the
117 This tunable enables a work-around to recover from receive hangs.
119 Set to 0 to disable the work-around.
122 The following read-only variables are available as
125 .Bl -tag -width "xxxxxxxx"
129 This variable counts the number of interrupts due to the GEM buffer ring
135 The number of times the GEM's transmit ring was full.
149 A 64-bit counter of the number of bytes transmitted in frames without error.
186 Counter of frames experiencing deferral due to carrier sense being
189 Counter of frames transmitted where carrier sense was not seen during
190 transmission or where carrier sense was deasserted after being asserted
193 A 64-bit counter of bytes received without error excluding pause
204 Counter of 64-byte frames received without error.
254 .%T "Zynq-7000 SoC Technical Reference Manual (Xilinx doc UG585)"
255 .%U http://www.xilinx.com/support/documentation/user_guides/\:ug585-Zynq-7000-TRM.pdf
286 The GEM used in the Zynq-7000 has a bug such that the receiver can
289 "Known Issues" of the Zynq-7000 SoC Technical Reference Manual (Xilinx
293 driver implements the work-around suggested in the manual.
295 SiFive SoCs so the work-around is disabled in those instances and enabled
297 The work-around can be disabled by setting the