288 	 * If we're checking a link-layer header for a packet encapsulated
339 	 * that later filters apply to the encapsulated payload.
1294 		 * is being used and pick out the encapsulated Ethernet type.  in init_linktype()
1311 		 * is being used and pick out the encapsulated Ethernet type.  in init_linktype()
1350 		 * is being used and pick out the encapsulated Ethernet type.  in init_linktype()
1376 		 * the encapsulated DLT should be DLT_IEEE802_11) we  in init_linktype()
1417 		cstate->off_linkpl.constant_part = cstate->off_payload;	/* if LLC-encapsulated */  in init_linktype()
1464 		 * is being used and pick out the encapsulated Ethernet type.  in init_linktype()
1476 		 * XXX - we should set this to handle SNAP-encapsulated  in init_linktype()
2012 		 *	(encapsulated Ethernet) and a protocol  in gen_ether_linktype()
2074 		 * 802.2-encapsulated ETHERTYPE_ATALK packets are  in gen_ether_linktype()
2079 		 * 802.2-encapsulated ETHERTYPE_AARP packets are  in gen_ether_linktype()
2081 		 * 0x000000 (encapsulated Ethernet) and a protocol  in gen_ether_linktype()
2241 		 *	(encapsulated Ethernet) and a protocol  in gen_linux_sll_linktype()
2287 		 * 802.2-encapsulated ETHERTYPE_ATALK packets are  in gen_linux_sll_linktype()
2292 		 * 802.2-encapsulated ETHERTYPE_AARP packets are  in gen_linux_sll_linktype()
2294 		 * 0x000000 (encapsulated Ethernet) and a protocol  in gen_linux_sll_linktype()
2611  * encapsulation only (i.e. the encapsulated DLT should be
3158 		 * This is LANE-encapsulated Ethernet; check that the LANE  in gen_prevlinkhdr_check()
3198 	/* are we checking MPLS-encapsulated packets? */  in gen_linktype()
3273 		 * Check for an LLC-encapsulated version of this protocol;  in gen_linktype()
3974 		 * 802.2-encapsulated ETHERTYPE_ATALK packets are  in gen_llc_linktype()
3980 		 * encapsulated Ethernet as well?  in gen_llc_linktype()
4002 			 * 0x000000 (encapsulated Ethernet).  in gen_llc_linktype()
4006 			 * organization code of 0x000000 (encapsulated  in gen_llc_linktype()
4931  * Generate a check for IPv4 or IPv6 for MPLS-encapsulated packets;
4983 		 * checking MPLS-encapsulated packets.  in gen_host()
5722 	 * For LLC-encapsulated ATM/"Classical IP", RFC 1483 and  in gen_port()
6449 		 * For LLC-encapsulated ATM/"Classical IP", RFC 1483 and  in gen_proto()
6574 			 * XXX - what about SNAP-encapsulated frames?  in gen_proto()
9189 	/* can't check for VLAN-encapsulated packets inside MPLS */  in gen_vlan()
9197 	 * "vlan 300 && vlan 200" to capture VLAN 200 encapsulated within  in gen_vlan()
9214 	 * both for VLAN-encapsulated IP and IP-over-Ethernet, rather than  in gen_vlan()
9215 	 * checking only for VLAN-encapsulated IP, so that could still  in gen_vlan()
9231 		 * not encapsulated somehow. */  in gen_vlan()
9343 	 * we're checking MPLS-encapsulated headers, to make sure higher  in gen_mpls()
9412 	 * encapsulated in PPPoES instead), so the link-layer type  in gen_pppoes()
9536  * - The offset of the end of the encapsulated MAC header. */
9593 	/* Set the encapsulated type as Ethernet. Even though we may  in gen_geneve_offsets()
9707 /* Check that the encapsulated frame has a link layer header
9910 		 * rather than LLC-encapsulated packets, and set  in gen_atmtype_abbrev()
9911 		 * the offsets appropriately for LANE-encapsulated  in gen_atmtype_abbrev()
9926 		/* Get all LLC-encapsulated packets */  in gen_atmtype_abbrev()