ASoC: spacemit: fix RX DMA params not set when TX is running

When TX is already running (SSCR_SSE is set), the hw_params callback
returns early before setting up DMA parameters for the RX stream. Th

ASoC: spacemit: fix RX DMA params not set when TX is running

When TX is already running (SSCR_SSE is set), the hw_params callback
returns early before setting up DMA parameters for the RX stream. This
prevents the capture path from configuring its DMA data properly.

Move the SSCR_SSE check after DMA parameter setup and format
constraints, so both TX and RX streams get their DMA configuration
regardless of whether the hardware is already enabled. The early return
now only skips the register writes that would disrupt an active stream.

Fixes: fce217449075 ("ASoC: spacemit: add i2s support for K1 SoC")
Signed-off-by: Troy Mitchell <troy.mitchell@linux.spacemit.com>
Link: https://patch.msgid.link/20260429-k1-i2s-fix-v2-1-8d67835aaddc@linux.spacemit.com
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...

ASoC: spacemit: adjust FIFO trigger threshold to half FIFO size

Set both TX and RX FIFO trigger thresholds (TFT/RFT) to 0xF (half of
the 32-entry FIFO) instead of 5. This provides better DMA efficie

ASoC: spacemit: adjust FIFO trigger threshold to half FIFO size

Set both TX and RX FIFO trigger thresholds (TFT/RFT) to 0xF (half of
the 32-entry FIFO) instead of 5. This provides better DMA efficiency
by allowing more data to accumulate before triggering a DMA request,
reducing the number of DMA transactions needed.

Signed-off-by: Troy Mitchell <troy.mitchell@linux.spacemit.com>
Link: https://patch.msgid.link/20260429-k3-i2s-v1-3-2fe99db11ecb@linux.spacemit.com
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...

ASoC: spacemit: move hw constraints from hw_params to startup

Hardware constraints should be applied in the startup callback rather
than hw_params, as hw_params may be called too late for the constr

ASoC: spacemit: move hw constraints from hw_params to startup

Hardware constraints should be applied in the startup callback rather
than hw_params, as hw_params may be called too late for the constraints
to take effect properly.

Move the channel count and format constraints for I2S and DSP_A/DSP_B
modes into a new startup callback. This also tightens the I2S mode
channel constraint from 1-2 to exactly 2, matching the actual hardware
behavior.

Signed-off-by: Troy Mitchell <troy.mitchell@linux.spacemit.com>
Link: https://patch.msgid.link/20260429-k3-i2s-v1-2-2fe99db11ecb@linux.spacemit.com
Signed-off-by: Mark Brown <broonie@kernel.org>

show more ...